How to change name of devices in packet tracer There are two ways that I know of that can allow you to make the change You can double click on the tag "laptop0" and change it from the text box
How do i set up a static route between 3 routers on a packet tracer . . . i have 3 routers on my packet tracer: r1, r2 and r3 i connect r1 and r2 using a DTE DCE cable on serial ports s2 0 and r2 and r3 using DTE DCE cable on serial ports s3 0 i basically do this on each of these routers: R1>enable R1#configure terminal R1(config)#interface sX 0 Here X means the respective port numbers for any routers
cisco - Wireshark capture in Packet tracer - Stack Overflow As far as I know, In Packet Tracer you cannot use Wireshark You can use Packet Tracer's built in simulation and packet filters to track packets Other than Packet Tracer, There are two solutions to your problem: Physically connect two PCs and just run Wireshark on one PC's network adapter You can see everything there is between the two of them
Adding Tracer beans in Spring Boot with OpenTelemetry This responsibility should be handled by the application, possibly using some runtime-specific support (e g providing a Tracer @Bean in Spring Boot, or a CDI producer) Framework integrations used to instrument-specific technologies should not use this library, but should allow a Tracer to be injected instead, with fallback to the GlobalTracer
How to plot all the stream lines in paraview? - Stack Overflow To add a little bit to Mathieu's answer, if you really want streamlines everywhere, then you can create a Stream Tracer With Custom Source (as Mathieu suggested) and set your data to both the Input and the Seed Source That will create a streamline originating from every point in your dataset, which is pretty much what you asked for