英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：


请选择你想看的字典辞典：
单词字典翻译
Paixhans查看　Paixhans　在百度字典中的解释百度英翻中〔查看〕
Paixhans查看　Paixhans　在Google字典中的解释Google英翻中〔查看〕
Paixhans查看　Paixhans　在Yahoo字典中的解释Yahoo英翻中〔查看〕

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Band-pass active 4th order filter with cutoff frequencies 400 kHz and . . .
    Hello, I have to make a Band-pass active 4th order filter with cutoff frequencies 400 kHz and 500 kHz, output impedance less than 50 ohm, operating voltage range between 4 and 12 V Supply voltage +-15 V And use Orcad Pspice can someone tell me how to make the scheme, because I am new to
  • Solved Design a bandpass filter (see figure below) with a - Chegg
    Question: Design a bandpass filter (see figure below) with a center frequency of 2 kHz and a bandwidth of 500 Hz Use a 200 Ω resistor
  • Bandpass Filter Question - All About Circuits
    Design a two-stage "bandpass" RC filter, in which the first stage is highpass with a breakpoint of 100Hz, and the second stage is lowpass with a breakpoint of 10kHz Assume the input signal source has an impedance of 100Ω What is the worst-case output impedance of your filter, and therefore what is the minimum recommended load impedance?
  • square wave -- gt;sine using passive bandpass filter - All About Circuits
    Hi, I'm designing a circuit that will take a square wave generated by a microprocessor and feeds it through a bandpass filter to get a sine wave The application will be to provide a tone for morse code to a handheld ham radio on board a small satellite Right now im considering remaining
  • Multiple Feedback Bandpass Filter vs Inverting Bandpass Filter
    Hi all, I want to filter a band of frequencies between 50Hz to 300Hz I am currently using the Inverting Bandpass Filter design as shown below: I am now planning to increase to roll-off of the filter Will a Multiple Feedback Bandpass Filter work since I have a narrow pass-band? I was
  • Bandpass Filter Design for All Audible Frequencies
    I agree with Joey Separate low-pass and high-pass filters would be better for flatness For maximum flatness in the passband you want to use Butterworth filter types The free Filterpro program from Texas Instruments will help you design 4th order active filters
  • Solved Part A Designing the bandpass filter By specifying - Chegg
    The figures show a cascaded op amp bandpass filter and bandreject filter Part A - Designing the bandpass filter By specifying the values for RL, RH, and Rf, design a bandpass filter to have a low frequency cutoff of fc 1=325Hz, a high-frequency cutoff of fc 2=9000Hz,and an amplification of 2 5 in the passband Part B - Designing the Bandreject
  • Active Band Pass Filter (20Hz - 500Hz) | All About Circuits
    The multiple-feedback-bandpass-filter produces plenty of output at 10kHz even when its -3dB cutoff is 500Hz because it is much too simple with very gradual slopes A second-order bandpass provides - far above the corner frequencies - a first order slope (20dB dec)





中文字典-英文字典  2005-2009